[omd-users] Changing 'scale' of graphs

Dennis Sweben d_sweben at hotmail.com
Mon Feb 5 14:09:57 CET 2018

Oops, too fast for the reply.
I just had to give it a few more pulls from the firewall before the graphs switched ☺

Thanks! Please ignore previous message

From: "0.o Dennis o.0" <d_sweben at hotmail.com>
Date: 2-5-2018 at 14:07
To: Andreas Döhler <andreas.doehler at gmail.com>
Cc: "omd-users at lists.mathias-kettner.de" <omd-users at lists.mathias-kettner.de>
Subject: Re: [omd-users] Changing 'scale' of graphs

Hi Andreas,

Thanks for the response.
I already did try to setup a rule in ‘Network interfaces and switch ports’
Explicit hosts: “Firewall_1”
Port specification: “Interface Adaptive Security Appliance OBS interface”

Assumed input speed: manually: 50000000
Assumed output speed: manually: 50000000

And hit save, and activate, but it’s not showing any difference.

The graph still shows the Y line from top to bottom: 10, 5, 0, -5, -10 MB/sec
Please note: I did make changes to the ‘Network Interface and Switch Port Discovery’ to discover the ‘VLAN’s that are set.
Which I’m monitoring.

Please let me know how to find out the correct ‘Port specification’ for this interface.

Thanks in advance!

From: Andreas Döhler <andreas.doehler at gmail.com>
Date: 2-5-2018 at 13:57
To: "0.o Dennis o.0" <d_sweben at hotmail.com>
Cc: "omd-users at lists.mathias-kettner.de" <omd-users at lists.mathias-kettner.de>
Subject: Re: [omd-users] Changing 'scale' of graphs

Hi Dennis,

for every interface you can define an "assumed input/output speed". This settings will be then also used inside
generated graphs.


Dennis Sweben <d_sweben at hotmail.com<mailto:d_sweben at hotmail.com>> schrieb am Mo., 29. Jan. 2018 um 13:41 Uhr:
Hi all,

I’m monitoring a Cisco ASA, for point of interest I’m monitoring data usage of some VLAN’s.
The main ones are all 100Mbit/s and the graph shows nice with a ‘cap’ on 10MByte/s
However I have 2 other VLAN’s which operate on a ‘cap’ of 30Mbit and 50Mbit, and the scale is the same as the 100Mbit.
How can I change the operating speed to monitor for example:
Interface Adaptive Security Appliance OBS interface

To be 30Mbit/s (3MByte/s)

Because the graph is hard to ‘read’ at the moment.

Thanks in advance!
omd-users mailing list
omd-users at lists.mathias-kettner.de<mailto:omd-users at lists.mathias-kettner.de>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.mathias-kettner.de/pipermail/omd-users/attachments/20180205/5b077daf/attachment.html>

More information about the omd-users mailing list